7 configuring limit values, Configuring limit values, Commissioning – Rice Lake PR5230 Fieldbus Transmitter User Manual
Page 150: Pr 5230 instrument manual
Commissioning
PR 5230 Instrument Manual
EN-150
Sartorius
5.7
Configuring Limit Values
Each limit value consists of a switch-on and a switch-off point for definition of a hysteresis. The three pairs of
values must be entered according to the same principle. The limit values always refer to the gross weight.
The limit values of an xBPI weighing point are scale-specific.
-
The scale must be active when entering the limit values.
-
The scale and the unit must not be changed after configuration.
-
The following settings are required:
[Weighingpoint/xBPI-Scale]-[Setup]-[Configuration]-[Application settings]-
[Number of units]: [1 Weight]
Define the limit values under
-[Limit parameter].
Press
to select the specific items.
Press
to select the respective parameter.
Setup/
Limit parameter
Determine the limit values.
Limit 1 on
890 kg
Action
-no action-
Limit 1 off
900 kg
Action
-no action-
Limit 2 on
300 kg
Action
-no action-
Limit 2 off
290 kg
Action
-no action-