Rice Lake PR5230 Fieldbus Transmitter - Manual (Page 79)

PR 5230 Instrument Manual Installing the Instrument and Plug-in Cards
Sartorius EN-79
4.4.5.3 9-Pole D-Sub Connector ‚IN’
E.g. Phoenix Contact IBS RTC-T
Pin allocation acc. to
DIN 41642
Signal Color
DIN 47100
Description
Cable sheath green special InterBus cable (certified)
1 ----------------------------- IDO1 green inverted data output
2 ----------------------------- DO1 yellow not inverted data output
3 ----------------------------- IDI1 pink inverted data input
4 ----------------------------- DI1 grey not inverted data input
5 ----------------------------- GND brown signal - ground
6 ----------------------------- S Screen
4.4.5.4 9-Pole D-Sub Connector ‚OUT’
E.g. Phoenix Contact IBS RTC-T
Pin allocation acc. to
DIN 41642
Signal Color
DIN 47100
Description
Cable sheath green special InterBus cable (certified)
7 ----------------------------- IDO2 green inverted data output
8 ----------------------------- DO2 yellow not inverted data output
9 ----------------------------- IDI2 pink inverted data input
10 ---------------------------- DI2 grey not inverted data input
11 --------- * only if necessary GND brown signal - ground
(continuation jumper: 11-12)
12 --------- * only if necessary C Con_Test (continuation jumper: 11-12)
13 ----------------------------- S Screen
4.4.5.5 Connecting Diagram for a Master with three Slaves
Caution!
With Bus OUT 11 and 12 must be bridged, if another slave follows. Thus the link is not
fitted at the last slave, see next page.
Caution!
The cable screens must be taken into the instrument through the cable glands and
connected to terminals 6 or 13 (see next page).
Before, during and after installation, make sure that the sealing rings are seated
correctly.