CANOGA PERKINS 9175 Command Reference - Manual (Page 104)

CanogaOS Command Reference
7-1
7 Spanning-tree Commands
7.1 spanning-tree enable
Use this command to enable the Spanning Tree Protocol on a bridge. Use the no parameter to disable
the SpanningTree Protocol on the bridge.
Command Syntax
spanning-tree enable
no spanning-tree enable
Command Mode
Configure mode
Default
Usage
Configure the bridge instance name before using this command. The allowable range of values is 1-10
seconds.
Examples
Switch# configure terminal
Switch(config)# spanning-tree enable
Switch# configure terminal
Switch(config)# no spanning-tree enable
Related Commands
7.2 spanning-tree priority
Use this command to set the bridge priority for the common instance for the default bridge. Using a lower
priority indicates a greater likelihood of the bridge becoming root. Use the no parameter with this
command to reset it to the default value.
Command Syntax
spanning-tree priority priority
no spanning-tree priority
priority Bridge priority. The range is 0 to 61440.
Command Mode
Configure mode