CANOGA PERKINS 9175 Command Reference - Manual (Page 420)

CanogaOS Command Reference
25-8
25.9 debug ldp events
Use this command to monitor all LDP events, such as sending packets and
receiving packets.
Note:
On using a debug command the router continues to generate an
output until the no parameter is used with the command. The
debug output and system error messages are written on the
virtual terminal. Use the log file or log syslog command in the
configure mode to redirect the debugging output to a file or the
syslog
Command Syntax
(no) debug ldp events
Syntax Description
This command has no arguments or keywords.
Command Mode
Privileged Exec mode
Defaults
This command has no default settings.
Examples
In the following example, the debug ldp events command is used to monitor
all LDP events:
Switch# debug ldp events
2002/06/18 11:30:35 LDP: RECV packet from 192.168.3.5 port 32783
2002/06/18 11:30:35 LDP: ldp_message_hello_recv: Hello Packet received from
192.168.3.5
2002/06/18 11:30:36 LDP: ldp_message_hello_send: Sending Hello message via
interface
eth1. No transport address is being advertised.
2002/06/18 11:30:36 LDP: SEND to socket 13 port 646 addr 224.0.0.2
2002/06/18 11:30:36 LDP: ldp_message_hello_send: Sending Hello message via
interface
eth2. No transport address is being advertised.