CANOGA PERKINS 9175 Command Reference - Manual (Page 456)

CanogaOS Command Reference
25-44
Related Commands
25.49 targeted-peer-hold-time
Use this command to set the time-out value that is the time that the router waits
before rejecting an adjacency with targeted peers. Use the no parameter to
revert to the default targeted-peer hold-time value.
Command Syntax
(no) targeted-peer-hold-time number
Syntax description
number Specifies the interval in seconds, the range is 3
to 65535
Command Mode
Router mode
Defaults
The default is 45 seconds.
Examples
In the following example, the targeted-peer-hold-time command is used to set
the time-out value that is the time that the router waits before rejecting an
adjacency with targeted peers:
Switch# configure terminal
Switch(config)# router ldp
Switch(config-router)# targeted-peer-hold-time 100
Related Commands
show ldp
ldp targeted-peer-hold-time
25.50 transport-address
Use this command to configure the transport address for a label space. Use the
no parameter to stop using the transport-address as the IPv4 transport address.