CANOGA PERKINS 9175 Command Reference - Manual (Page 724)

CanogaOS Command Reference
40-53
Command Syntax
logging server {enable | disable}
enable Enable logging server.
disable Disable logging server.
Command Mode
Global configuration
Default
Logging operations is disabled
Usage
Examples
The following is sample output from the logging server command.
Switch(config)# logging server enable
Related Commands
logging server severity
40.73 logging server address
To log system messages and debug output to a remote server, use the logging server address
command in global configuration mode. To remove a specified logging server from the configuration, use
the no form of this command.
Command Syntax
logging server address ip-address
no logging server address ip-address
ip-address IP address of the server that will receive the system logging messages.
Command Mode
Global configuration
Default
System logging messages are not sent to any remote server.
Usage
The logging server address command identifies a remote server (usually a device serving as a syslog
server) to receive logging messages. By issuing this command more than once, you can build a list of
servers that receive logging messages.
Examples