CANOGA PERKINS 9175 Command Reference - Manual (Page 538)

CanogaOS Command Reference
30-7
reply-mode
MODE Specifies the reply mode for the echo request
packet.
z Reply with IP UDP packet (default)
z Reply with IP UDP packet with router alert
timeout
TIME_OUT Specifies the timeout interval in seconds. The
range is from 1 to 500. Default is 60.
ttl TTL_VAL Specifies the TTL value to be used in the
MPLS labels.
The range is from 1 to 255. Default is 255.
Command Mode
Privileged Exec mode
Defaults
This command has no default settings.
Examples
In the following example, the traceroute mpls l2-circuit command is used to
initiate tracing the route traversed by the specified Layer-2 VC echo request
packet in the MPLS cloud.
Switch# traceroute mpls l2-circuit 100 source 10.10.10.10 destination 127.0.0.1
dsmap detail flags interval 100 repeat 100 reply-mode timeout 100 ttl 200
Related Commands
ping mpls l2-circuit
30.6 traceroute mpls l3vpn
Use this command to initiate tracing the route traversed by the specified VPN
instance echo request packet in the MPLS cloud.
Command Syntax
traceroute mpls l3vpn VRFNAME A.B.C.D/M source A.B.C.D [destination
A.B.C.D | detail | dsmap | flags | interval INT_VAL | repeat REP_VAL |
reply-mode MODE | timeout TIME_OUT | ttl TTL_VAL]
Syntax Description
VRFNAME Layer-2 VC ID.
A.B.C.D/M BGP VPN prefix.
source A.B.C.D Specifies the source address used in the echo
request packet.
destination
A.B.C.D Specifies a network 127/8 address to be used
as the destination address in the echo request
packet.
detail Enables verbose output information, including