17 spanning-tree edgeport, 18 spanning-tree edgeport bpdu-guard – CANOGA PERKINS 9175 Command Reference User Manual
Page 114
CanogaOS Command Reference
7-11
Switch(config-if)# spanning-tree link-type shared
Related Commands
7.17 spanning-tree edgeport
Use this command to set a port as an edge-port and to enable rapid transitions. Use the no parameter
with this command to set a port to its default state (not an edge-port) and to disable rapid transitions.
Command Syntax
spanning-tree edgeport
no spanning-tree edgeport
Command Mode
Interface mode
Default
Usage
Examples
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)# spanning-tree edgeport
Related Commands
7.18 spanning-tree edgeport bpdu-guard
Use this command to enable or disable the BPDU Guard feature on a port. Use the no parameter with
this command to set the BPDU Guard feature on a port to default.
Command Syntax
spanning-tree edgeport bpdu-guard {enable | disable | default}
no spanning-tree edgeport bpdu-guard
Command Mode
Interface mode
Default
BPDU guard is disabled.