CANOGA PERKINS 9175 Command Reference - Manual (Page 165)

CanogaOS Command Reference
10-8
Usage
1 ˅This command is used to transmit a loopback message for a MAC address to a remote MP for fault
verification.
2 ˅This command is used to transmit a loopback message to a remote MEP for fault
verification.
Examples
Switch# loopback ethernet mpid 88 level 7 vlan 30
Switch# loopback ethernet 8908.0909.1267 level 7 vlan 30 repeat 5 timeout 5
Related Commands
10.12 CFM linktrace tests
Use the procedures in this section to issue CFM path trace messages and to discover the path to a remote
MEP.
Command Syntax
linktrace ethernet MAC (domain DOMAIN | level LEVEL) vlan VLANID
(ttl TTL|) ( timeout TIMEOUT|)
linktrace ethernet mep MEPID (domain DOMAIN | level LEVEL) vlan VLANID
(ttl TTL|) ( timeout TIMEOUT|)
Command Mode
Privileged Exec mode
Default
The default TTL is 64.
The default timeout is 10 seconds.
Usage
1 ˅This command is used to transmit a loopback message for a MAC address to a remote
MEP for Path discovery.
2 ˅This command is used to transmit a loopback message to a remote MEP for Path
discovery.
Examples
Switch# linktrace ethernet mep 88 level 7 vlan 30 ttl 64 timeout 5
Switch# linktrace ethernet 3456.0908.0908 level 7 vlan 30 ttl 64 timeout 5