11 related commandsmpls propagate-ttl – CANOGA PERKINS 9175 Command Reference User Manual
Page 467
CanogaOS Command Reference
26-9
This command has no arguments or keywords.
Command Mode
Interface mode
Defaults
Label switch function is disabled.
Examples
In the following example, the label-switching command is used to enable an
interface’s label switch function:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)#
label-switching
26.11 Related Commandsmpls propagate-ttl
Use this command to enable mpls propagate-ttl function.
Command Syntax
(no) mpls propagate-ttl
Syntax Description
This command has no arguments or keywords.
Command Mode
Configure mode
Defaults
Mpls propagate-ttl is enabled.
Examples
In the following example, the mpls propagate-ttl command is used to enable
mpls propagate-ttl function:
Switch# configure terminal
Switch(config)#
mpls propagate-ttl
Related Commands