CANOGA PERKINS 9175 Command Reference - Manual (Page 311)

CanogaOS Command Reference
16-66
Interface Send Recv Key-chain
eth0 2 2
Routing for Networks:
10.10.0.0/24
Routing Information Sources:
Gateway BadPackets BadRoutes Distance Last Update
Distance: (default is 120
16.101 timers
Use this command sets the BGP keepalive timer and holdtime timer values.
Use the no parameter with this command to reset timers to default value.
Command Syntax
timers bgp KEEPALIVE HOLDTIME
no timers bgp
KEEPALIVE <0-65535> The frequency with which the keepalive messages are sent to the neighbors.
The default value is 60 seconds.
HOLDTIME <0-65535> The interval after which the neighbor is considered dead if keepalive messages
are not received. The default holdtime value is 180 seconds.
Command Mode
Router mode
Usage
This command is used globally to set or unset the keepalive and holdtime values for all the neighbors.
Examples
Switch# configure terminal
Switch(config)# router bgp 10
Switch(config-router)# timers bgp 40 120
16.102 undebug bgp
Use this command to disable BGP debugging functions.
Command Syntax
undebug bgp (all|dampening|events|filters|fsm|keepalives|mpls|nsm|updates)
undebug all bgp
all Disable all debugging for BGP
dampening Disable debugging for BGP dampening.
events Disable debugging for BGP events.