27 ldp multicast-hellos, 28 ldp targeted-peer-hello-interval – CANOGA PERKINS 9175 Command Reference User Manual
Page 436
CanogaOS Command Reference
25-24
25.27 ldp multicast-hellos
Use this command to enable multicast hello exchange on a specified interface.
Use the no parameter to disable multicast hello exchange.
Command Syntax
(no) ldp multicast-hellos
Syntax Description
This command has no arguments or keywords.
Command Mode
Interface mode
Defaults
Disabled
Examples
In the following example, the ldp multicast-hellos command is used to
enable multicast hello exchange on a specified interface:
Switch# configure terminal
Switch(config)# interface eth-0-1
Switch(config-if)#
ldp multicast-hellos
Related Commands
25.28 ldp targeted-peer-hello-interval
Use this command to set the interval for sending unicast hello packets to
targeted peers via this interface. Use the no parameter to revert to the
targeted-peer hello-interval value set for the main LDP process.
Command Syntax
(no) ldp targeted-peer-hello-interval number
Syntax Description
number
Specifies the interval in seconds, the range is 1
to 21845