CANOGA PERKINS 9175 Command Reference - Manual (Page 234)

CanogaOS Command Reference
15-25
the number argument are the only options that are applicable.
This keyword does not apply to nonbroadcast multiaccess (NBMA)
networks.
Default
No configuration is specified.
Command Mode
Router configuration
Usage
One neighbor entry must be included in the switch configuration for each known nonbroadcast network
neighbor. The neighbor address must be on the primary address of the interface.
If a neighboring router has become inactive (hello packets have not been received for the Router Dead
Interval period), it may still be necessary to send hello packets to the dead neighbor. These hello
packets will be sent at a reduced rate called Poll Interval.
When the router first starts up, it sends only hello packets to those routers with nonzero priority, that is,
routers that are eligible to become designated routers (DRs) and backup designated routers (BDRs).
After the DR and BDR are selected, DR and BDR will then start sending hello packets to all neighbors in
order to form adjacencies.
Examples
The following example declares a router at address 192.168.3.4 on a nonbroadcast network, with a
priority of 1 and a poll interval of 180 seconds:
router ospf
neighbor 192.168.3.4 priority 1 poll-interval 180
Related Commands
ip ospf priority
15.29 network area (OSPF)
To define the interfaces on which Open Shortest Path First (OSPF) runs and to define the area ID for
those interfaces, use the network area command in router configuration mode. To disable OSPF routing
for interfaces defined with the address wildcard-mask pair, use the no form of this command.
Command Syntax
network {ip-address wildcard-mask | ip-address/prefix-length} area area-id
no network {ip-address wildcard-mask | ip-address/prefix-length} area area-id
ip-address IP address.
wildcard-mask IP-address-type mask that includes “don’t care” bits.
prefix-length Prefix length for the network.
area-id Area that is to be associated with the OSPF address range. It can be
specified as either a decimal value or as an IP address.