CANOGA PERKINS 9175 Command Reference - Manual (Page 97)

CanogaOS Command Reference
6-7
6.11 vlan classifier rule
Use this command to create vlan classifier rule.
To remove the vlan classifier rule, use the no form of this command.
Command Syntax
vlan classifier rule rule { ip ipv4_address | ipv6 ipv6_address | mac mac_address |
protocol { arp |ip | ip-or-ipv6 | ipv6 | mpls | mpls-mcast | rarp } } vlan <1-4094>
rule :<0-255> the id of vlan classifier rule
ipv4_address: the source of ipv4 address in packets
ipv6_address: the source of ipv6 address in packets
mac_address: the source of mac address in packets
{arp|ip|ip-or-ipv6|ipv6|mpls|mpls-mcast|rarp}: the protocol specified
<1-4094>: the vlan id to assign
Command Mode
Global configuration
Usage
The rule will be effective only in inbound on interface.
The vlan id assigned by vlan classifier rule will override the original vlan id it has.
To add this rule to vlan classifier group or apply the group to an interface, reference to vlan classifier
group and vlan classifier activate command.
Examples
This example shows how to create rule1 which will apply vlan11 to all the ipv4 packets:
Switch(config)# vlan classifier rule 1 protocol ip vlan 11
This example shows how to delete rule1:
Switch(config)# no vlan classifier rule 1
Related Commands
vlan classifier group
vlan classifier activate
6.12 show vlan classifier group
Use this command to show the information about vlan classifier group.
Command Syntax
show vlan classifier group group
group: <0-31> the id of vlan classifier group
Command Mode
EXEC