CANOGA PERKINS 9175 Command Reference - Manual (Page 293)

CanogaOS Command Reference
16-48
16.72 neighbor version
Use this command to configure the software to accept only a particular BGP version.
Use the no parameter with this command to use the default version level of a neighbor.
Command Syntax
(no) neighbor NEIGHBORID version VERSION
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used with a command,
the command applies on all peers in the specified group.
VERSION= 4 | 4- Specifies the BGP version number.
4 Border Gateway Protocol 4
Command Mode
Router mode
Usage
By default, the system uses BGP version 4 and on request dynamically negotiates down to version 2. Using
this command disables the router’s version-negotiation capability and forces the router to use only a specified
version with the neighbor.
Examples
Switch# configure terminal
Switch(config)# router bgp 12
Switch(config-router)# neighbor 10.10.10.10 version 4
16.73 neighbor weight
Use this command to set default weights for routes from this neighbor.
Use the no parameter with this command to remove a weight assignment.
Command Syntax
(no) neighbor NEIGHBORID weight WEIGHT
NEIGHBORID = A.B.C.D|X:X::X:X|TAG
A.B.C.D Specifies the address of the BGP neighbor in IPv4 format.
X:X::X:X Specifies the address of the BGP neighbor in IPv6 format.
TAG Name of an existing peer-group. For information on how to create peer groups, refer to the
neighbor peer-group and neighbor remote-as commands. When this parameter is used with a command,
the command applies on all peers in the specified group.
WEIGHT= <0-65535> Specifies the weight this command assigns to the route.