CANOGA PERKINS 9175 Command Reference - Manual (Page 40)

CanogaOS Command Reference
3-6
Examples
In the following example, the quit command is used to move from global configuration mode to
privileged EXEC mode, the disable command is used to move from privileged EXEC mode to user
EXEC mode, and the quit command is used to log off (exit the active session):
Switch(config)# quit
Switch# disable
Switch> quit
Related Commands
exit
3.9 terminal length
To set the number of lines on the current terminal screen for the current session, use the terminal
length command in EXEC mode. To restore the configuration to the default, use the no form of this
command.
Command Syntax
terminal length screen-length
terminal no length
screen-length Number of lines on the screen. The value is a number from 0 to 512. A value of
zero disables pausing between screens of output.
Default
Automatically detected by terminal screen length.
Command Mode
EXEC
Usage
The system uses the length value to determine when to pause during multiple-screen output. A value of
zero prevents the switch from pausing between screens of output.
Some types of terminal sessions do not require you to specify the screen length because the screen
length specified can be learned by some remote hosts. For example, the rlogin protocol uses the screen
length to set up terminal parameters on a remote UNIX host.
Examples
In the following example, the system is configured to prevent output from pausing if it exceeds the
length of the screen:
Switch# terminal length 0
Related Commands
service terminal-length