CANOGA PERKINS 9175 Command Reference - Manual (Page 163)

10-6
The default is disable.
Usage
The level ID identifies the domain to which configuration applies.
1) Enter enable to enable CFM cc for the domain level.
2) 20 Enter a maintenance level as a level number (0 to 7) or as any for all maintenance levels.
3) Enter the VLANs to apply the check to, as a VLAN-ID (1 to 4095), a range of VLAN-IDs separated
by a hyphen, a series of VLAN IDs separated by commas,or any for any VLANs.
4)
Examples
Switch#configure terminal
Switch(config)# ethernet cfm cc level 7 vlan 30 interval 5
Related Commands
10.9 Configure CC transmission interval
Use this command to set cc transmissions interval.
Command Syntax
ethernet cfm cc level LEVEL vlan VLAN_ID (interval ( 1000 | 10000 | 60000 | 600000))
Command Mode
Configure mode
Default
Transmit interval default value is 10000ms.
Usage
None
Examples
Switch#configure terminal
Switch(config)# ethernet cfm cc level 7 vlan 30 intreval 10000
Related Commands
10.10 Configuring a Maintenance Intermediate Point
Use this command to define an MIP.
CanogaOS Command Reference