CANOGA PERKINS 9175 Command Reference - Manual (Page 457)

CanogaOS Command Reference
25-45
If the label-space is not specified in either form of this command, a label-space
of zero is assumed.
Command Syntax
(no) transport-address A.B.C.D
Syntax description
A.B.C.D The IPv4 address to be used as the transport
address. Only addresses bound to a loopback
interface are valid for manual transport address
configuration
Command Mode
Router mode
Defaults
By default, transport addresses are chosen for label spaces. These addresses
might either be bound to a loopback interface, or to a physical interface that is
bound to the label space in question.
Examples
In the following example, the transport-address command is used to configure
the transport address for a label space:
Switch# configure router
Switch(config)# router ldp
Switch(config-router)# transport-address 10.10.0.5
Related Commands
25.51 show ldp vpls
Use this command to display information about all VPLS instances. Specify the
VPLS ID to display information about a specific VPLS instance.
Command Syntax
show ldp vpls [detail | VPLS_ID]
Syntax description