CANOGA PERKINS 9175 Command Reference - Manual (Page 511)

CanogaOS Command Reference
28-23
This command sets the metric value for a route, and influences external neighbors about the
preferred path into an Autonomous System (AS). The preferred path is the one with a lower
metric value. A router compares metrics for paths from neighbors in the same ASs. To compare
metrics from neighbors coming from different ASs, use the bgp always-compare-med command.
To use the set metric command, you must first have a match clause. Match and set commands
set the conditions for redistributing routes from one routing protocol to another. The match
command specifies the match criteria under which redistribution is allowed for the current
route-map. The set command specifies the set redistribution actions to be performed, if the
match criteria are met.
If the packets do not match any of the defined criteria, they are routed through the normal
routing process.
Note:
This command is valid for BGP, OSPF and RIP only.
Command Syntax
set metric METRICVAL
no set metric
Syntax Description
METRICVAL <+/-metric>|<0-4294967295> The metric value.
Command Mode
Route-map mode
Defaults
No set metric is specified by default.
Examples
Switch# configure terminal
Switch(config)# route-map rmap1 permit 3
Switch(config-route-map)# set metric 600
Related Commands
28.24 set metric-type
Use this command to set the metric type for the destination routing protocol.
Use the no parameter with this command to return to the default.