CANOGA PERKINS 9175 Command Reference - Manual (Page 739)

CanogaOS Command Reference
41-1
41 Mirror Commands
41.1 monitor session destination interface
Use this command to set mirror destination interface.
To remove this setting, use the no form of this command.
Command Syntax
monitor session < session > destination interface interface
no monitor session < session > destination
session: <1-4> mirror session number
interface: Mirror destination interface
Command Mode
Global configuration
Usage
The destination interface can only be physical port such as eth-0-1. It can be neither vlan interface nor
agg interface.
Examples
This example shows how to set the mirror destination port to eth-0-1 in session 1.
Switch(config)# monitor session 1 destination interface eth-0-1
This example shows how to remove this setting.
Switch(config)# no monitor session 1 destination
Related Commands
monitor session source interface
monitor session source vlan
show monitor
41.2 monitor session source interface
Use this command to set mirror source interface.
To remove this setting, use the no form of this command.
Command Syntax
monitor session < session > source interface interface [both | tx |rx]
no monitor session < session > source interface interface [both | tx |rx]
session: <1-4> mirror session number
interface: mirror source interface. It can be either physical port or agg interface. (I.e. eth-0-1, agg1)
both: monitor received and transmitted traffic on that interface
rx: monitor received traffic only on that interface