CANOGA PERKINS 9175 Command Reference - Manual (Page 762)

CanogaOS Command Reference
44-7
Global configuration
Usage
Examples
The following is an example of a system location string:
Switch(config)# snmp-server system-location Sample Place
Related Commands
snmp-server system-contact
44.10 snmp-server trap enable
To enable all Simple Network Management Protocol (SNMP) notification types that are available on your
system, use the snmp-server trap enable command in global configuration mode. To disable all
available SNMP notifications, use the no form of this command.
Command Syntax
snmp-server trap enable notification-type
no snmp-server trap enable notification-type
notification-type Type of notification to enable or disable. If the all argument is specified,
all notifications available on your device are enabled or disabled (if the
no form is used).
Default
No notifications controlled by this command are sent.
Command Mode
Global configuration
Usage
The snmp-server trap enable command is used in conjunction with the snmp-server trap
target-address command. Use the snmp-server trap target-address command to specify which host
or hosts receive SNMP notifications. To send notifications, you must configure at least one snmp-server
trap target-address command.
Examples
The following is sample output from the snmp-server trap enable command:
Switch(config)# snmp-server trap enable all
Related Commands
snmp-server trap target-address