CANOGA PERKINS 9175 Command Reference - Manual (Page 231)

CanogaOS Command Reference
15-22
no switchport
ip address 192.168.77.17/24
ip ospf network non-broadcast
Related Commands
neighbor (OSPF)
15.25 ip ospf priority
To set the router priority, which helps determine the designated router for this network, use the ip ospf
priority command in interface configuration mode. To return to the default value, use the no form of this
command.
Command Syntax
ip ospf priority number-value
no ip ospf priority
number-value A number value that specifies the priority of the router. The range is from 0
to 255.
Default
Priority of 1
Command Mode
Interface configuration
Usage
When two routers attached to a network both attempt to become the designated router, the one with the
higher router priority takes precedence. If there is a tie, the router with the higher router ID takes
precedence. A router with a router priority set to zero is ineligible to become the designated router or
backup designated router. Router priority is configured only for interfaces to multiaccess networks (in
other words, not to point-to-point networks).
This priority value is used when you configure Open Shortest Path First (OSPF) for nonbroadcast
networks using the neighbor router configuration command for OSPF.
Examples
The following example sets the router priority value to 4:
interface eth-0-1
ip ospf priority 4
Related Commands
ip ospf network
neighbor (OSPF)