CANOGA PERKINS 9175 Command Reference - Manual (Page 294)

CanogaOS Command Reference
16-49
Command Mode
Router mode
Usage
Use this command to specify a weight value to all routes learned from a neighbor. The route with the highest
weight gets preference when there are other routes on the network.
Unlike the local-preference attribute, the weight attribute is relevant only to the local router.
The weights assigned using the set weight command overrides the weights assigned using this command.
Examples
Switch# configure terminal
Switch(config)# router bgp 12
Switch(config-router)# neighbor 10.10.10.10 weight 60
16.74 network
Use this command to specify the networks to be advertised by the BGP routing process. A unicast network
address without a mask is accepted if it falls into the natural boundary of its class. A class-boundary mask is
derived if the address matches its natural class-boundary.
Use the no form of this command to remove a network route entry.
Command Syntax
[no] network A.B.C.D
A.B.C.D IP prefix <network>, e.g., 35.0.0.0
[no] network A.B.C.D route-map WORD
A.B.C.D IP prefix <network>, e.g., 35.0.0.0
WORD Name of the route map
Command Mode
Router mode and IPv4-Unicast Address-family mode
Examples
The following example illustrates a Class-A address configured as a network route. The natural Class-A
network prefix mask length of 8 will be internally derived, that is, 2.0.0.0/8.
Switch(config)#router bgp 1
Switch(config-router)#network 2.0.0.0
Switch#show run
!
router bgp 1
no synchronization
network 1.0.0.0
!
The following example illustrates a network address which does not fall into its