CANOGA PERKINS 9175 Command Reference - Manual (Page 164)

CanogaOS Command Reference
10-7
Command Syntax
ethernet cfm mip level LEVEL
no ethernet cfm mip level LEVEL
Command Mode
Interface mode
Default
No MIPs are configured.
Usage
1) This command creates a MIP for every VLAN allowed on an interface, but you must first create a
domain using the ethernet cfm domain command. If you do not have a domain configured at the
same level, the ethernet cfm mip level command is rejected.
2) You cannot configure a MIP at a level lower than the level of already configured maintenance end
points (MEPs) on an interface.
3)
Examples
Switch#configure terminal
Switch(config)# ethernet cfm mip level 7
Related Commands
10.11 CFM loopback tests
Use the command to issue CFM loopback messages and verify that remote MEPs or MIPs are accessible.
Command Syntax
loopback ethernet MACADDRESS (domain DOMAIN_NAME | level LEVEL) vlan
VLAN_ID (repeat COUNT|)( timeout TIMEOUT|) (source MEPID|)
loopback ethernet mpid MEPID (domain DOMAIN_NAME | level LEVEL) vlan
VLAN_ID (repeat COUNT|)( timeout TIMEOUT|)
Command Mode
Privileged Exec mode
Default
The default repeat is1.
The default timeout is 5 seconds.