CANOGA PERKINS 9175 Command Reference - Manual (Page 567)

CanogaOS Command Reference
31-28
None
31.41 service-policy
Use this command to configure a policy for interface to match the traffic defined by class-map, do
according actions.
Command Syntax
(no)service-policy (input | output) NAME
Service-policy: Configure QoS Service Policy
input: Assign policy-map to the input of an interface
output: Assign policy-map to the output of an interface
NAME: Specify a policy-map name
Command Mode
Interface configuration
Usage
Use the service-policy interface configuration command to apply a policy map defined by the policy-map
command to the input or output of a particular interface. Use the no form of this command to remove the
policy map and interface association.
Examples
Configure a policy to ingress of a physical interface
Switch(config)#interface eth-0-1
Switch(config-if)#service-policy input plc_map1
Remove a policy from ingress of a physical interface
Switch(config-if)#no service-policy input
Related Commands
None
31.42 qos policer flow-first
Use this command to configure the order of executing between port-policing and flow-policing
Command Syntax
(no)qos policer flow-first
flow-first: Flow-policing first when there are port-policing and flow-policing at the same time.
Command Mode
Global configuration
Usage