CANOGA PERKINS 9175 Command Reference - Manual (Page 434)

CanogaOS Command Reference
25-22
Defaults
The default is 15 seconds.
Examples
In the following example, the ldp hold-time command is used to set the
hold-time value after which the LSR rejects adjacencies:
Switch # configure terminal
Switch (config)# interface eth-0-1
Switch (config-if)# ldp hold-time 635
Related Commands
hello-interval
hold-time
ldp hello-interval
25.25 ldp keepalive-interval
Use this command to set the interval for sending keep-alive messages to the
peer in order to maintain a session. Use the no parameter to revert to the
keep-alive interval set for the main LDP process.
Command Syntax
(no) ldp keepalive-interval number
Syntax Description
number Specifies the interval in seconds, the range is
10 to 21845
Command Mode
Interface mode
Defaults
The default is 10 seconds
Examples
In the following example, the ldp keepalive-interval command is used to set
the interval for sending keep-alive messages to the peer in order to maintain a