46 related commandstargeted-peer, 47 targeted-peer-hello-interval – CANOGA PERKINS 9175 Command Reference User Manual
Page 454
CanogaOS Command Reference
25-42
25.46 Related Commandstargeted-peer
Use this command to specify a targeted LDP peer.
Command Syntax
targeted-peer A.B.C.D
Syntax description
A.B.C.D
Specifies the IPv4 address of the targeted peer.
Command Mode
Router mode
Defaults
This command has no default settings.
Examples
In the following example, the targeted-peer command is used to specify a
targeted LDP peer:
Switch# configure terminal
Switch(config)# router ldp
Switch(config-router)#
targeted-peer 10.10.10.10
Related Commands
25.47 targeted-peer-hello-interval
Use this command to set the interval for sending unicast hello packets to
targeted peers. Use the no parameter with this command to revert to the
default targeted-peer hello-interval value.
Command Syntax
(no) targeted-peer-hello-interval number
Syntax description
number
Specifies the interval in seconds, the range is 1
to 21845.