4 configuring a maintenance association, 5 configuring a maintenance end point – CANOGA PERKINS 9175 Command Reference User Manual
Page 160
CanogaOS Command Reference
10-3
Usage
The MD level. To configure the level, enter a value in the range 0 to 7. The levels define the MD as
follows:
0~2 (operator levels)
3~4 (provider levels)
5~7 (customer levels)
Examples
Switch#configure terminal
Switch(config)# ethernet cfm enable
Switch#configure terminal
Switch(config)# no ethernet cfm enable
Related Commands
10.4 Configuring a Maintenance Association
Use the command to define an MA within an MD.
Command Syntax
service CSI_ID vlan VLAN_ID
no service CSI_ID vlan VLAN_ID
Command Mode
Ethernet-cfm configuration mode
Default
None
Usage
Related Commands
ethernet cfm domain DOMAIN_NAME level LEVE
10.5 Configuring a Maintenance End Point
Use the command to define an MEP within an MA. Each MEP and remote MEP must have a unique ID within
an MA. If two or more MEPs share the same ID, CFM raises an event indicating a duplicate MEP exists in the
MA.
Command Syntax