CANOGA PERKINS 9175 Command Reference - Manual (Page 584)

CanogaOS Command Reference
32-9
32.12 queue <0-3> threshold
Use this command to configure Tail Drop threshold for each queue in a network egress policy.
Command Syntax
queue <0-3> threshold THRESH1 THRESH2 THRESH3
no queue <0-3> threshold
THRESH1: The drop threshold for red-colored packets. If the current queue length is greater than the
threshold, all incoming red-colored packets will be dropped.
THRESH2: The drop threshold for yellow-colored packets. If the current queue length is greater than the
threshold, all incoming yellow-colored packets will be dropped.
THRESH3: The drop threshold for green-colored packets. If the current queue length is greater than the
threshold, all incoming green-colored packets will be dropped.
Command Mode
Network Egress Policy Configuration
Usage
When the queue threshold is configured, all EVCs associated with the network egress policy will use the
set of queue threshold values.
Examples
In the following example, the queue <0-3> threshold command is used to set drop threshold for queue
0.
Switch(config)# qos net-egress evc110-policy-at-egress-nni
Switch(config-net-egress)# queue 0 threshold 16 24 32
Related Commands
None
32.13 ethernet evc reserved start-vlan
Use this command to reserve a range of VLAN for creating EVC. To remove the reserved VLAN range of
EVC, used to no form of this command.
Command Syntax
ethernet evc reserved start-vlan FROM-VLAN number VLAN-NUMBER
no ethernet evc reserved vlan
FROM-VLAN: The start VLAN ID of the reserved VLAN range.
VLAN-NUMBER: The number of reserved VLAN ID.