CANOGA PERKINS 9175 Command Reference - Manual (Page 96)

CanogaOS Command Reference
6-6
This example shows how to apply vlan classifier group 1 to the interface:
Switch(config-if)# vlan classifier activate 1 based ip
This example shows how to remove the vlan classifier group 1 from the interface:
Switch(config-if)# no vlan classifier activate
Related Commands
vlan classifier group
vlan classifier rule
6.10 vlan classifier group
Use this command to add or delete rule to vlan classifier group.
To remove the group, use the no form of this command.
Command Syntax
vlan classifier group group {add|delete} rule rule
group: <0-31> the id of vlan classifier group
{add|delete}: add or delete rule to vlan classifier group
rule: the id of rule
Command Mode
Global configuration
Usage
To create the rule, reference to vlan classifier rule command.
To apply the vlan classifier group to an interface, reference to vlan classifier activate command.
When add a rule to the group by this command, the rule will be active even if the group has been apply
to an interface already.
When delete a rule from the group by this command, the rule on this interface will be inactive even if the
group is still apply to that interface.
The vlan classifier group will be deleted when the last rule on this group is deleted.
Examples
This example shows how to add rule1 to vlan classifier group 1:
Switch(config)# vlan classifier group 1 add rule 1
This example shows how to delete rule2 to vlan classifier group 1:
Switch(config)# vlan classifier group 1 delete rule 1
Related Commands
vlan classifier activate
vlan classifier rule