CANOGA PERKINS 9175 Command Reference - Manual (Page 577)

CanogaOS Command Reference
32-2
Usage
None
Examples
In the following example, the description command is used to add a description clause for the SAP
egress policy.
Switch(config)# qos sap-egress evc110-policy-at-egress-uni
Switch(config-sap-egress)# description “used for policing evc 110”
Related Commands
None
32.3 total-rate
Use this command to configure a group shaping rate in an SAP egress policy. The group shaping in an
SAP egress policy rate-limits the total bandwidth leaving from the egress UNI for relevant EVC. There is
no default value assigned for the total rate immediately after the SAP egress policy being created. So, to
associate the egress SAP policy with some EVCs, user should configure the total-rate manually.
Command Syntax
total-rate RATE
RATE: The group shaping rate, whose value ranges from 0 to 1000, 000 kbps.
Command Mode
SAP Egress Policy Configuration
Usage
1. The total-rate should be at least be the sum rate of queue-rate of queue 1 - queue 3.
2. An SAP egress policy can be associated with multiple EVCs, the total-rate is not to limit the total
traffic of all EVCs, but to rate-limit the maximum allowed bandwidth at egress UNI for each EVC
separately.
Examples
In the following example, the total-rate command is used to shape a EVC’s total traffic in conforming to
20Mbps at the egress UNI direction.
Switch(config)# qos sap-egress evc110-policy-at-egress-uni
Switch(config-sap-egress)# total-rate 20000
Related Commands
None