Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 137)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 4-11
Global Configuration Mode
Global Configuration Commands
dial-peer voice
dial-peer voice pots fxs
Use the dial-peer voice pots fxs command to allow access to the Dial Peer Voice FXS
configuration commands. See Chapter 8, Configuration - Dial Peer FXS Mode for commands in
this mode. For the no counterpart of this command see no dial-peer voice pots fxs command on
page 4-38.
Syntax:
(config)# dial-peer voice pots fxs port
Example:
(config)# dial-peer voice pots fxs 1
(config-dpeer-fxs)#
Supported Platforms: Adit 3104, Adit 3500, MSR
dial-peer voice pots trunk
Use the dial-peer voice pots trunk command to allow access to the Dial Peer Voice Trunk
configuration commands. See Chapter 9, Configuration - Dial Peer Trunk Mode for commands in
this mode. For the no counterpart of this command see no dial-peer voice pots trunk command on
page 4-38. Note: This command is not supported on the Adit 3104.
Syntax:
(config)# dial-peer voice pots trunk port dest-port
Example:
(config)# dial-peer voice pots trunk 2 1
(config-dpeer-trk)#
Supported Platforms: Adit 3500, MSR
Field Definition
port Selects the FXS port to configure.
Adit 3104: Range is 1-24.
Adit 3500: Range is 1-4.
MSR: Range is 1-48.
Field Definition
port Select the trunk port to configure.
Adit 3500: Range = 1-4
MSR: Value must be 1.
dest-port Set destination port. Range is 1-30.