Codec preference, Destination-pattern, Codec preference -3 destination-pattern -3 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 221
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
8-3
Configuration - Dial Peer FXS Mode
codec preference
Use the Dial Peer codec preference command to set the codec preferences used to establish the codec
list offered during media negotiation. To delete a codec, see no codec preference command on page 8-9.
Syntax:
(config-dpeer-fxs)# codec preference {1|2|3} {g711alaw|
g711ulaw|g729}
Example:
(config-dpeer-fxs)# codec preference 1 g711alaw
Supported Platforms:
Adit 3104, Adit 3500, MSR
destination-pattern
Use the Dial Peer destination-pattern command to define the full telephone number to be used for a
dial peer.
Syntax:
(config-dpeer-fxs)# destination-pattern
number
Example:
(config-dpeer-fxs)# destination-pattern 5551212
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field
Definition
1|2|3
Enter the preference number. #1 being the first preference.
g711alaw
Set the codec preference to G.711 A-law.
g711ulaw
Set the codec preference to G.711 U-law.
g729
Set the codec preference to G.729.
Note: This codec is not supported by the Adit 3500 or MSR for FXS.
Field
Definition
number
Enter the phone number to be used for a dial peer.