Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 346)

15-4 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - L2TPC Mode
history
Use the history command to display commands that have been entered in this session. This command
can be entered in any configuration mode.
Syntax:
(config-l2tpc-{n})# history
Example:
(config-l2tpc-1)# history
firewall enable
exit
host-ip 192.168.1.10
ip default-route enable
ip rip enable
ip rip send-version none
ip primary-dns 192.168.2.10
ip route 192.168.1.160
history
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
host-ip
Use the L2TPC host-ip command to configure the IP address for the host.
Syntax:
(config-l2tpc-{n})# host-ip { address}
Example:
(config-l2tpc-1)# host-ip 192.168.2.101
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address Enter the IP address for the host.