Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 467)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 25-7
Configuration - Voice Service SIP Mode
fax-protocol-t38 signaling
Use the Voice Service SIP fax-protocol-t38 signaling command to configure fax signaling.
Note: For the MSR, T.38 will be supported in a future release.
Syntax:
(config-voice-serv-sip)# fax-protocol-t38 signaling
{nse-only|nse-preferred|sdp-only|sdp-preferred}
Example:
(config-voice-serv-sip)# fax-protocol-t38 signaling
sdp-preferred
Syntax Descriptions:
Supported Platforms: Adit 3104, Adit 3500, MSR
feature-mode
Use the Voice Service SIP feature-mode command to determine where the intelligence for the calling
features will lie, offering a choice between server-based (Info) and device-based (local) features.
Syntax:
(config-voice-serv-sip)# feature-mode {info|local}
Example:
(config-voice-serv-sip)# feature-mode info
Supported Platforms: Adit 3104, Adit 3500, MSR
Variable Definition
nse-only Named Service Element (NSE) will be the only method tried without any
attempt to try alternate signaling method to establish connection if it fails.
sdp-only Session Description Protocol (SDP) will be the only method tried without any
attempt to try alternate signaling method to establish connection if it fails.
nse-preferred Named Service Element (NSE) preferred will be the first method tried with an
attempt to try the alternate SDP signaling method to connect if it fails.
sdp-preferred Session Description Protocol (SDP) preferred will be the first method tried
with an attempt to try the alternate NSE signaling method to connect if it fails.
Default.
Field Definition
info This selection is used with BroadSoft 11.1 Info Mode Proxy. Note: On
a BroadSoft server, the Adit device must be configured as “Generic
SIP Standard (Proxy Address)”.
local Default is Local.