No ip ospf dead-interval, No ip ospf disable, No ip ospf hello-interval – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 357
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
15-15
Configuration - L2TPC Mode
no ip ospf dead-interval
Use the L2TPC no ip ospf dead-interval command to reset the interval of time to the default setting
of 40 seconds. To define the interval of time that no hello packets have been seen before neighbors
declare the router down, see ip ospf dead-interval command on page 15-7.
Syntax:
(config-l2tpc-{n})# no ip ospf dead-interval
Example:
(config-l2tpc-1)# no ip ospf dead-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf disable
Use the L2TPC no ip ospf disable command to enable OSPF processing on this interface. To
disable OSPF on this interface, see ip ospf disable command on page 15-8.
Syntax:
(config-l2tpc-{n})# ip ospf disable all
Example:
(config-l2tpc-1)# ip ospf disable all
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf hello-interval
Use the L2TPC no ip ospf hello-interval command to reset the interval of time to the default setting
of the path cost to the default setting of 10 seconds. To define the interval of time between hello
packets sent on the interface, see ip ospf hello-interval command on page 15-8.
Syntax:
(config-l2tpc-{n})# no ip ospf hello-interval
Example:
(config-l2tpc-1)# no ip ospf hello-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR