No ip ospf authentication-key, No ip ospf cost, No ip ospf dead-interval – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual

Page 392: No ip ospf disable

Advertising
background image

17-14

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI

Configuration - PPTPC Mode

no ip ospf authentication-key

Use the PPTP Client no ip ospf authentication-key command to remove a password to be used by
neighboring routers, that are using OSPF’s simple password authentication.To assign a password,
see ip ospf authentication-key command on page 17-7.

Syntax:

(config-pptpc-{n})# no ip ospf authentication-key

Example:

(config-pptpc-1)# no ip ospf authentication-key

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf cost

Use the PPTP Client no ip ospf cost command to reset the cost path to the default setting of 0. To
define the cost of sending a packet on this serial interface, see ip ospf cost command on page 17-7.

Syntax:

(config-pptpc-{n})# no ip ospf cost

Example:

(config-pptpc-1)# no ip ospf cost

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf dead-interval

Use the PPTP Client no ip ospf dead-interval command to reset the interval of time to the default
setting of 40 seconds. To define the interval of time that no hello packets have been seen before
neighbors declare the router down, see ip ospf dead-interval command on page 17-7.

Syntax:

(config-pptpc-{n})# no ip ospf dead-interval

Example:

(config-pptpc-1)# no ip ospf dead-interval

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500, MSR

no ip ospf disable

Use the PPTP Client no ip ospf disable command to enable OSPF processing on this interface. To
disable OSPF on this interface, see ip ospf disable command on page 17-8.

Syntax:

(config-pptpc-{n})# no ip ospf disable all

Example:

(config-pptpc-1)# no ip ospf disable all

Supported Platforms:

Adit 3104, Adit 3200, Adit 3500, MSR

Advertising