Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 142)

4-16 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Global Configuration Mode
Global Configuration Commands
dynamic-dns wildcard
Use the dynamic-dns wildcard command to enable the Dynamic DNS wildcard.
Syntax:
(config)# dynamic-dns wildcard enable
Example:
(config)# dynamic-dns wildcard enable
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
end
Use the end command to exit the current configuration mode. Note: This command can be entered in
any configuration mode with the same result.
Syntax:
(config)# end
Example:
(config)# end
#
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax:
(config)# exit
Example:
(config)# exit
#
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR