Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 233)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 9-5
Configuration - Dial Peer Trunk Mode
history
Use the history command to display commands that have been entered in this session.
Syntax:
(config-dpeer-trk)# history
Example:
(config-dpeer-trk)# history
destination-pattern
fax-protocol none
modem-protocol pass-through
sip-authentication enable
strip-digits
history
Supported Platforms: Adit 3500, MSR
modem-protocol
Use the Dial Peer modem-protocol command to configure the modem protocol.
Syntax:
(config-dpeer-trk)# modem-protocol {none|pass-through}
Example:
(config-dpeer-trk)# modem-protocol pass-though
Supported Platforms: Adit 3500, MSR
Field Definition
none A Modem call would be treated as a normal voice call. Default.
pass-through Will cause the line to transmit in G.711 mode, with echo cancellation
and silence suppression disabled, on detection of Modem tone.