Comfort-noise, Connection lcc, Connection t1 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 446
24-2
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port Trunk Mode
comfort-noise
Use the Voice Port Trunk comfort-noise command to enable the comfort noise feature. To disable this
feature, see no comfort-noise command on page 24-8.
Syntax:
(config-vport-trk-{
n})# comfort-noise enable
Example:
(config-vport-trk-1)# comfort-noise enable
Supported Platforms:
Adit 3500, MSR
connection lcc
Use the Voice Port Trunk connection lcc command to connect an MSR Link Cross Connect (LCC). To
disconnect this connection, see the no connection lcc command on page 24-8.
Syntax:
(config-vport-trk-{
n})# connection lcc number
Example:
(config-vport-trk-1)# connection lcc 2
Supported Platforms:
MSR
connection t1
Use the Voice Port Trunk connection t1 command to enter the T1 connection configuration mode. To
disconnect this connection, see no connection t1 command on page 24-8.
Syntax:
(config-vport-trk-{
n})# connection t1 port
Example:
(config-vport-trk-1)# connection t1 2
Supported Platforms:
Adit 3500
Field
Definition
number
Link Cross Connect. Range = 1-8.
Field
Definition
port
T1 port range 1-4.