No ip ospf retransmit-interval, No ip ospf transmit-delay, No ip primary-dns – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 287: No ip rip
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
12-17
Configuration - Multilink Interface Mode
no ip ospf retransmit-interval
Use the Multilink Interface ip ospf retransmit-interval command to restore the default value of 5
seconds. To define the interval of time between link state advertisement retransmissions for
adjacencies belonging to the interface, see ip ospf retransmit-interval command on page 12-10.
Syntax:
(config-int-mlink-{
n})# no ip ospf retransmit-interval
Example:
(config-int-mlink-1)# no ip ospf retransmit-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf transmit-delay
Use the Multilink Interface no ip ospf transmit-delay command to restore the default value of 1
second. To define the estimated time to transmit a link state update packet on the interface, see ip
ospf transmit-delay command on page 12-10.
Syntax:
(config-int-mlink-{
n})# no ip ospf transmit-delay
Example:
(config-int-mlink-1)# no ip ospf transmit-delay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip primary-dns
Use the Multilink Interface no primary-dns command to disable the primary DNS. To set the DNS
primary IP address, see ip primary-dns command on page 12-11.
Syntax:
(config-int-mlink-{
n})# no ip primary-dns
Example:
(config-int-mlink-1)# no ip primary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip rip
Use the Multilink Interface no ip rip command to disable RIP on this interface.
To enable RIP, see
Syntax:
(config-int-mlink-{
n})# no ip rip
Example:
(config-int-mlink-1)# no ip rip
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR