Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 282)

12-12 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Multilink Interface Mode
ip rip send-version
Use the Multilink Interface ip rip send-version command to configure the send RIP messages on
this interface
.
Syntax:
(config-int-mlink-{ n})# ip rip send-version {1|2-bcast|2-mcast
|none}
Example:
(config-int-mlink-1)# ip rip send-version 2-bcast
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
ip route
Use the Multilink Interface ip route command to configure the IP routing on this interface. To delete a
route, see no ip route command on page 12-18.
Syntax:
(config-int-mlink-{ n})# ip route dest-ip-addr mask mask gateway
gateway metric metric
Example:
(config-int-mlink-1)# ip route 192.168.100.200 mask
255.255.255.0 gateway 192.168.100.254 mask 125
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
1 Send RIP version 1.
2-bcast Send RIP version 2 - Broadcast.
2-mcast Send RIP version 2 - Multicast.
none Set RIP version to none.
Field Definition
dest-ip-addr Enter the destination IP address.
mask Enter the mask of the above address.
gateway Enter the gateway IP address.
metric Metric of IP network on this interface in Routing Table. Range is 0-
255, with a default is 10.