Redundancy ttl, Redundancy type, Redundancy ttl -16 redundancy type -16 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 476
25-16
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Service SIP Mode
redundancy ttl
Use the Voice Service SIP redundancy ttl command to set the set the SRV Time To Live (TTL) option.
The TTL is a set interval of time between flushing the SRV cache.
Syntax:
(config-voice-serv-sip)# redundancy ttl
seconds
Example:
(config-voice-serv-sip)# redundancy ttl 900
Supported Platforms:
Adit 3104, Adit 3500, MSR
redundancy type
Use the Voice Service SIP redundancy type command to configure the redundancy type.
Syntax:
(config-voice-serv-sip)# redundancy type {none|srv|user}
Example:
(config-voice-serv-sip)# redundancy type none
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field
Definition
seconds
Range 0 - 3600 seconds, with a default of 3600.
Field
Definition
none
Redundancy feature is disabled. Default.
srv
An SRV lookup will be performed using the main proxy. The hosts/
IPs found are used to form the proxy redundancy list.
user
The SIP messages will be sent to the primary proxy. If there is a failure
it will be sent to the secondary proxy.