Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 452)

24-8 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port Trunk Mode
no commands
no comfort-noise
Use the Voice Port Trunk no comfort-noise command to disable comfort noise. To enable remote
access, see comfort-noise command on page 24-2.
Syntax:
(config-vport-trk-{n})# no comfort-noise
Example:
(config-vport-trk-1)# no comfort-noise
Supported Platforms: Adit 3500, MSR
no connection lcc
Use the Voice Port Trunk no connection lcc command to remove a Link Cross Connection (LCC).
To add an LCC, see the connection lcc command on page 24-2.
Syntax:
(config-vport-trk-{ n})# no connection lcc number
Example:
(config-vport-trk-1)# no connection lcc 2
Supported Platforms: MSR
no connection t1
Use the Voice Port Trunk no connection t1 command to remove a T1 connection. To enter the T1
connection configuration mode, see connection t1 command on page 24-2.
Syntax:
(config-vport-trk-{ n})# no connection t1 port
Example:
(config-vport-trk-1)# no connection t1 2
Supported Platforms: Adit 3500
Field Definition
number Enter a current LCC connection. Range = 1-8.
Field Definition
port Enter a current T1 connection. T1 port range 1-4.