No digit-map (global), No digit-map (global) -5 tos -5 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 435
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
22-5
Configuration - Voice Port Mode
no digit-map (global)
Use the Voice Port no digit-map command to remove a digit map pattern. To configure digit map, see
digit-map (global) command on page 22-2.
Syntax:
(config-vport)# no digit-map pattern
number
Example:
(config-vport)# no digit-map pattern 10
Supported Platforms:
Adit 3104, Adit 3500, MSR
tos
Use the Voice Port tos command to set the Type of Service (ToS). This command sets the precedence
bits in the TOS byte of the IP header to prioritize packet handling.
Syntax:
(config-vport)# tos {rtp value
hex-value|sip value hex-value}
Example:
(config-vport)# tos rtp 0xb8
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field
Definition
pattern number
Enter pattern number to remove. Range is 1-30.
See show digit-map command on page 3-37, to display the current list
of Digit Map numbers.
Field
Definition
rtp value hex-value Range is 0x00 - 0xff. Default 0xb8
sip value hex-value
Range is 0x00 - 0xff. Default 0xdc