Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 292)

12-22 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Multilink Interface Mode
ppp link-fragmentation
Use the Multilink Interface ppp link-fragmentation command to configure the threshold byte size of
the packet, for Interleaving. Note: If the packet is > the set threshold, the packet will be split in half and
sent.
Syntax:
(config-int-mlink-{ n})# ppp link-fragmentation number
Example:
(config-int-mlink-1)# ppp link-fragmentation 600
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
ppp on-demand
Use the Multilink Interface ppp on-demand command to enable on demand the feature. On demand
attempts to connect only when packets are sent. To disable PPP on demand, see no ppp on-demand
command on page 12-19.
Syntax:
(config-int-mlink-{ n})# ppp on-demand
Example:
(config-int-mlink-1)# ppp on-demand
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
ppp password
Use the Multilink Interface ppp password command set the PPP password. To delete a PPP password,
see no ppp password command on page 12-19.
Syntax:
(config-int-mlink-{ n})# ppp password password
Example:
(config-int-mlink-1)# ppp username test-user-pswrd
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
number Range 320 - 1600, with a default of 1600 bytes.
Field Definition
password Enter the PPP password, with a maximum of 19 characters.