Exit, Firewall, End -3 exit -3 firewall -3 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 381
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
17-3
Configuration - PPTPC Mode
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file. This command can be entered in any configuration mode with the same result.
Syntax:
(config-pptpc-{n})# end
Example:
(config-pptpc-1)# end
#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax:
(config-pptpc-{n})# exit
Example:
(config-pptpc-1)# exit
(config)#
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
firewall
Use the PPTP Client firewall command to enable the configured firewall. To delete a preference, see
no firewall command on page 17-13.
Syntax:
(config-pptpc-{n})# firewall enable
Example:
(config-pptpc-1)# firewall enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR