Echo-cancel, Exit, Echo-cancel -4 end -4 exit -4 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 440
23-4
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Voice Port FXS Mode
echo-cancel
Use the Voice Port FXS echo-cancel command to enable Echo Cancellation on this trunk. To to disable
Echo Cancellation, see no echo-cancel command on page 23-6
Syntax:
(config-vport-fxs-{
n})# echo-cancel enable
Example:
(config-vport-fxs-1)# echo-cancel enable
Supported Platforms:
Adit 3104, Adit 3500, MSR
end
Use the end command to exit the current configuration mode, and must be used to mark the end of any
configuration file.
Syntax:
(config-vport-fxs-{
n})# end
Example:
(config-vport-fxs-1)# end
#
Supported Platforms:
Adit 3104, Adit 3500, MSR
exit
Use the exit command to close your current connection if you are in the User mode, or Privileged mode.
If the command is entered in a subconfiguration mode (Interface or Routing), this command takes you
to the next higher level (example: back to Privileged mode from Interface configuration mode).
Syntax:
(config-vport-fxs-{
n})# exit
Example:
(config-vport-fxs-1)# exit
(config)#
Supported Platforms:
Adit 3104, Adit 3500, MSR