Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 38)

2-14 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
User Mode
show interface ethernet
Use the show interface ethernet command to display the Ethernet interface information.
Syntax:
> show interface ethernet port
Example:
Adit 3500> show interface ethernet 1
Device=Ethernet 1 State=running IP/Mask=192.168.1.1/255.255.255.0
Dependency=None
Status: Connected; Link: 10T-HD
Tx (Packets/Bytes/Dropped/Errors)=(1620/1643674/0/0)
Rx (Packets/Bytes/Dropped/Errors)=(1636/143050/0/0)
Broadcasts (Tx/Rx)=(0/0) Multicasts=0 Collisions=0
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
show interface multilink
Use the show interface multilink command to display the multilink configuration information.
Syntax:
> show interface multilink port
Example:
Adit 3500> show interface multilink 1
Device=mlink-1 State=down IP/Mask=Unnumbered
Dependency=t1-1,t1-3
Status: Disconnected
Example:
Adit MSR> show interface multilink 1
Device=mlink-1 State=down IP/Mask=Unnumbered
Dependency=LCC1,LCC2
Status: Disconnected
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
port Ethernet port number. Range = 1-2.
Field Definition
port Multilink port number.
Adit 3104, Adit 3200, Adit 3500: Value must be 1.
MSR: Range is 1-8