Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 235)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 9-7
Configuration - Dial Peer Trunk Mode
prefix
Use the Dial Peer prefix command to define the prefix of the phone number.
Syntax:
(config-dpeer-trk)# prefix prefix
Example:
(config-dpeer-trk)# prefix 1303
Supported Platforms: Adit 3500, MSR
sip-authentication
Note: To delete SIP authentication, see no sip-authentication command on page 9-6.
sip-authentication enable
Use the Dial Peer sip-authentication enable command to enable SIP.
Syntax:
(config-dpeer-trk)# sip-authentication enable
Example:
(config-dpeer-trk)# sip-authentication enable
Supported Platforms: Adit 3500, MSR
sip-authentication password
Use the Dial Peer sip-authentication password command to set the SIP password.
Syntax:
(config-dpeer-trk)# sip-authentication password password
Example:
(config-dpeer-trk)# sip-authentication password
test-password
Supported Platforms: Adit 3500, MSR
Field Definition
prefix Prefix is the digits or a name to be added to the phone number after the
stripping process has been applied. Up to 10 digits may be entered.
Field Definition
password The password to be used when responding to authentication requests.